We fetch to your attention a new website where you can buy priligy australia at a low price with fast delivery to Australia.
3. FITTING THE GATEWAY HARNESS
When you have tested everything, refit your head unit.
Take care not to trap any wires
or the Dension
Once the head unit has been removed, disconnect the
The below diagram depicts how the different modules
. We supply cable ties to mount the Gateway
antenna cable (1)
and then unclip the main wiring
Five module. Please mount the module away from
connector from the head unit (2).
This will differ in all
heat or damp surfaces.
Refit of the Head Unit is the reversal of the removal
process for your specific vehicle, as per your
6. CAR-SPECIFIC CONNECTIONS
Connect the round iPod connector and AUX (
With the main radio cable removed, first connect the
to the module and feed them through the dashboard to
Dension supplied cable to the original factory cable
If you have a factory phone kit installed in your radio
the 4 pin molex
connector to the
position shown on fig. #2,
so that the phone audio could
come through the car speakers. Skipping this step will
lets you connect your iPod / iPhone to your
original car radio, providing music playback and menu based control and charging.
2. GETTING STARTED
At first please make sure that the vehicle
compatibility is correct.
The Dension iGateway is available in specific versions
for different vehicle types, therefore the exact operation and installation may be different in each case.
In some cases there may be an add-in connector. Remove the CD changer section and replace with the
loom supplied with the iGateway. For further details
During the installation always make sure that the
please go to section 6
ignition key is removed from the car, the radio is
Important installation notes for BMW owners
Warning! Do not trap the cables, or leave them in a
switched off and that you have the security code of
position where they may become trapped after
the head unit (radio) available (if applicable).
If the car has factory CD-Changer (CDC) in that case all
wires needs to be disconnected
from the factory CDC
refitting the head unit.
3. HOW TO REMOVE THE HEAD UNIT
(except if you install CD Retention Kit), otherwise you
Ensure the device is correctly fitted before running the
First, carefully remove your vehicle's existing factory fit
cable. Then, reconnect the Dension supplied main radio
head unit as per the factory instructions and using the
Important installation notes for Audi and BMW
Connect the 18 way micro-fit
(18 pin molex) to the Car
The free black
lead on the Gateway harness must be
grounded / connected
to the chassis of the radio
5. TEST AND REFIT
case of BMW you don’t need to connect this lead.
All photos / illustrations are for representation purposes
Before you refit the head unit, test the iGateway with
only and may differ visually from the equipment in your
your car audio, making sure all connections are correct
vehicle. Information correct at time of going to print E. &
O. E. Dension Audio Sytems Ltd. and it’s registered partners cannot be held liable for any damages caused
Note: If during testing you notice any changes or
by the incorrect installation of any Dension product.
inconsistencies in the way the car's electrical
system operates, disconnect the Gateway product
8. FURTHER ASSISTANCE
immediately and consult your dealer.
If you need further assistance in using your Dension
Important installation notes for BMW (
17 pin, round
product, please contact your local supplier or visit
www.dension.com/en/support and click on ‘Support’.
In some cases, removing the head unit will require panel
The white ISO connector can be connected in two ways.
Please check also the download section for the latest
removal as well therefore we recommend to contact
If you have full functionality without sound that means
firmware version and product documentation, as these
your vehicle's dealer or installation supplier / installer for
this connector has been connected in wrong way.
may provide additional features or easier use of the
Please rotate that connector by 180 degrees.
PRESCRIBING INFORMATION within an area may help reduce or prevent these reactions. Rarely injection site reactions may require discontinuation NovoRapid® of NovoRapid®. Hypoglycaemia may constitute a risk when driving or operating machinery. NovoRapid® must not be mixed with other medicinal products except for NPH (Neutral Protamine Hagedorn) insulin and some infusion fluids. Case
ATLANTIC MEDICAL IMAGING PRESCRIPTION DRUG PLAN INFORMATION EFFECTIVE 11/1/2013 Welcome to WellNet! The information below is a general description of your plan benefits and is not meant to be a complete list or complete description of available services. Please contact WellNet at 800-727-1733 with specific questions about your program. PRESCRIPTION DRUG COPAYS MAIL SERVI